SURFACEMAX 530
OPERATION MANUAL - WINTER SMOOTHING PLANER -
SURFACEMAX 530
,.
When processing bent surfaces always begin by small chip.
,.
If the machine stops suddenly (e.g. break of electricity, tear of
belts etc.) you must stop immediately the pushing of the piece.
Smoothing and grooving of pieces up to 65 mm thick.
Preparation for smoothing (fig. 11)
,.
The guard of the cutting shaft laying on the board is pushed
away by hand until the supporting ruler and is adjusted accord-
ing to the thickness of the piece by means of handle A.
,.
The piece is pushed
by the right hand a lit-
tle some below the
fig.11
guard of the cutting shaft; the guard should lay on the piece
(fig. 11).
Thicknessing /fig.
12, 13, 14/
fig. 12
,.
Piece is pushed for-
ward on the entry
board by the palms
of the hands, the
hands passing one
after another over the guard of the cutting shaft (fig. 12, 13/.
fig. 14
,.
As soon as practi-
cable, the piece is
pushed forward
only on the exit board (fig. 14/.
Preparation for grooving /fig. 15/
fig.13
,.
The piece touches the supporting ruler for grooving by the
right hand and is pushed forward on the entry board ap-
proximately to the front edge of the strap.
,.
The guard of the cut-
ting shaft is pushed
by the left hand until
it touches the piece.
Grooving /fig. 16/
,.
The left hand flexed in
fist presses the piece to
the supporting ruler
and the board, the
thumb being on the
piece.
,.
The right hand flexed
fig. 15
in fist pushes the piece forward, the thumb being on the piece.
fig. 16
Summary of Contents for SURFACEMAX 530
Page 38: ...DMA...
