•
Fuel system
Make sure that the quality of the fuel refers to
.
Make sure that fuel is available at the engine connection 45 (fuel inlet).
Make sure that the fuel system is full and the fuel can flow.
•
Exhaust gas system
Make sure that the exhaust gas system is ready for operation.
•
Power supply system
Make sure that the power supply system is ready for operation.
•
Leakage drain system
Make sure that the leakage drain tanks of the plant have sufficient capacity.
For a DF engine, also the systems that follow must be prepared for operation:
•
Gas system
Make sure that the quality of the gas refers to
WINGD-AA00-HA1-50-0000-00AAA-030J-
A
.
Make sure that gas is available at the engine connection 78 (gas supply inlet).
•
Pilot fuel system
Make sure that the quality of the pilot fuel refers to
Make sure that pilot fuel is available at the engine connection 76 (supply unit fuel pilot valve
inlet).
Make sure that the pilot fuel system is full and the pilot fuel can flow.
NOTE:
You can start a DF engine only in diesel mode.
8.1.2
Preparation if components are defective
You also can operate the engine, if components of the engine are defective and you cannot repair
the fault immediately. You have to do more preparations related to the defective component, refer
to chapter 10 Troubleshooting.
Obey the limits of operation, if components of the engine are not in operation, refer to
X52
AA00-0000-00AAA-120A-A
Operation Manual
Prepare the engine before start - general
Winterthur Gas & Diesel Ltd.
- 279 -
Issue 002 2018-11