12.4.2.2
Engine screening procedure
After you have done the running-in of the engine, you can get initial data for the engine. WinGD
recommends to do an engine screening procedure as follows:
1
Set the base feed rate to 0.9 g/kWh of the selected cylinder oil.
2
Operate the engine at different loads, eg 10%, 20%, 30% etc related to the sailing
conditions.
3
For each load do a piston underside drain oil sampling, refer to
4
For each load do an interpretation of the oil analysis, refer to
or
12.4.2.3
Piston underside drain oil sampling
Do a piston underside drain oil sampling and an oil analysis of each cylinder, refer to the procedure
in
9.2 Do an analysis of the cylinder oil
.
X52
AA00-0000-00AAA-030G-A
Operation Manual
Cylinder oils
Winterthur Gas & Diesel Ltd.
- 456 -
Issue 002 2018-11
