P A G E
|
3
Wintex Agro, Vilhelmsborgvej 15, DK-7700 Thisted
+45 97990800, contact@wintexagro.com, www.wintexagro.com
1.
STARTING THE WINTEX 3000
Start the vehicle, and deactivate the emergency stop. The red button must be up.
Make sure that the dead-man’s vigilance system is activated.
Note: The emergency stop must always be activated at long stops, or the battery might be
discharged.
2.
SELECTION OF PROGRAM
Program 1 takes a soil sample from 0-90 cm. The depth can be adjusted.
Program 2 takes soil samples from three different layers, from 0-30 cm and from 30-60 cm. The
depth can be adjusted infinitely variable.
Program 3 takes soil samples from three different layers, from 0-30 cm, from 30-60 cm and from 60-
90 cm. The depth can be adjusted infinitely variable.
The soil sampler is adjusted to standard rotation (= extra rotation “off”). It is possible to add an extra
rotation (= extra rotation “on”).
3.
ADJUSTING THE DEPTH
The lower sensor plate defines the depth in program 1, program 2 and in program 3. Loosen the
screws, and move the sensor plate up or down to the desired depth.
The sensor plates in the middle define where the soil sample in program 3 will be divided. The depth can
be adjusted. Loosen the screws, and move the sensor plates to the depth in which the soil sample shall
be divided.
