12
INSTALLATION PREPARATIONS
INSTALLATION PREPARATIONS
13
Remove the power plug from its socket now.
3.
Insert the belt from above into the swivel belt
winder.
4.
Place it onto the fi xing hook from below and
mount it.
Put the plug back into the socket.
Press the Up-button until the belt has completed
at least one entire turn on the winding wheel.
Next, pull the plug out of the mains socket again
and place the provided belt cover over the instal-
lation opening.
Install the swivel belt winder
5.
Mark the fi xing holes:
To do this, hold the swivel belt winder at the
desired mounting position and mark the fi xing
holes. Please make sure to mount it straight
upright!
For wall mounting, drill the fi xing holes with
a 6 mm masonry drill and insert the enclosed
dowels into the holes.
6.
Mount the swivel belt winder
Fixate the swivel belt winder with the enclosed
assembly screws.
•
Wall mounting = chipboard screw 4 x 40
mm with half round head
•
Window frame mounting = tapping screw
4.2 x 19 mm
7.
Install the optional light sensor
(not inclu-
ded in the scope of supply).
Simply insert the sensor’s plug into the corres-
ponding socket (at the bottom side of the
eWickler)
8.
Mount the sensor via suction cup onto the
window pane. Depending on its positioning you
decide to which level the roller shutter will be
lowered in case of sunshine.
Warning:
Please follow all the instructions because an incorrect assembly of the device can cause
serious injury.
Summary of Contents for eWickler Comfort eW910
Page 17: ...32 NOTES NOTES 33 ...