3.3 General Settings for Main Menu
Press “Lock” key on the front panel to enter the main menu. The LCD will display the
following pages where user can configure the parameters for the device:
User can press UP/DOWN buttons to specify menu item, and then press ENTER to
enter the submenus as below:
1)
Alarm Status
The alarm indicator will turn on if there is no A/V signals inputting or outputting bit rate
overflows. User then can enter this menu to check the error type.
2)
Input Setting
Under this menu, the LCD will show “2.1 Input 1”, “2.2 Input 2” and “2.3 ASI”.
‘2.1 Input 1’ and ‘2.2 Input 2’ respectively represent the two programs from the two input
modules. Users could set the video and audio encoding parameters for each program under
2.1 and 2.2.
1 Alarm Status
2 Input Setting
3 Modulate Setting
4 IP Output Setting
5 Network Setting
6 Saving Config
7 Loading Config
8 Version
2.1 Input 1
►
MPEG2 H.264
Interface
►
HDMI YPbPr CVBS
Select a right interface type from the
options provided. The device then can
automatically search the signal and
starts to encode.
2.1 Input 1
2.2 Input 2
2.3 ASI
