10
GAS TRACKER INSTALLATION & OPERATION MANUAL
Changing Alert Settings
▶ Alert settings are changed by going to the
Setup
tab and then clicking
Alerts
.
▶ Each alert must be clicked individually and changed to the desired value.
▶ Begin by clicking the desired alert (example:
Low Flow
).
▶ In the keypad area press the double arrow to delete the preexisting value.
▶ Type in the desired value on the keypad.
▶ Press
OK
.
▶ If an alert is to be disabled do so with the
Disable
button to the left of the keypad.
Changing Outputs
▶ Output settings are changed by clicking the
Setup
tab and then clicking the
Output
button.
▶ Each output can be modified by clicking the button under the output number.
▶ When selected, the new output replaces the one that was previously configured.
▶ Use the back button to go back to the
Setup
page.
▶ Configuring signals via the
Output
information can be found in
Appendix B
of the manual.
Updating the Unit’s Time
▶ Each
Gas Tracker
has multiple time zones that can be selected.
▶ If the Timezone needs changed, click the
Setup
tab.
▶ Press the
Timezone
button in the upper right hand corner.
▶ Select the appropriate time zone.
▶ If the time is out of sync for any reason the
Gas Tracker
must be connected to a PC. Do this
by following the instructions in the
Software Use
section of the manual under Information.
Changing Units
▶ If the units need changed from
Metric
to
Imperial
or vice versa do so on the
Setup
page.
▶ After clicking the
Setup
tab, click the button under the text
Units
. The text that shows in
the box (ie.
Imperial
) are the units that are selected.
Summary of Contents for GAS TRACKER
Page 2: ......
