Wire wizard GAS TRACKER, Installation & Operation Manual

7

OPERATING INSTRUCTIONS

▶ Power on the 

Gas Tracker

 using the power switch on the front cover.  

The touch screen interface will now begin to load. 

▶ When the 

Gas Tracker

 is plugged into the 24 V power supply and charging, the text    

Charging

 appears along the bottom of the display. When the battery is fully charged,  

the text 

Charging

 disappears and is replaced by the text 

Fully Charged

.

Initial Setup

▶ Once the unit is powered on and the  

touch screen has loaded it must be  

configured. Configuration requirements  

are completed in the 

Setup

 tab (Fig. 5).

▶ Click 

Setup

 on the left hand side of the  

touch screen interface. 

▶ Set the units by clicking the 

Units

button. The options are 

Metric

 and  

Imperial

. The current unit variation  

selected is what the data will be  

displayed in. 

▶ Select the timezone by clicking the  

Timezone

 button. Options with NA are  

for North American time zones 

and options with EU are for European  

time zones. Select from the following  

options (Fig. 6): 

NA-Eastern, NA-Central,  

NA-Mountain, NA-Arizona, NA-Pacific,  

EU-Western, EU-Central, EU-Eastern,  

EU-Fthr. East, Asia-China, Asia-Japan,  

 Asia-Korea,

 and 

Asia-India

. If the   

necessary timezone is not represented  

here, the UTC offset can be used. Do  

this by clicking the UTC Offset button.  

Select the proper hour offset from  

UTC. The range goes from -12 hours to +12 hours in 1 hour increments. Upon selecting the  

time zone, the page will automatically save and return back to the 

Setup

 page. If the time  

is incorrect it must be synced to a PC. Use the provided USB cable and the instructions in  

 the 

Software

 section of the manual under 

Information

 to complete this task. 

▶ To set the 

Gas Type 

and 

Cylinder Capacity

 press the 

Gas Setup

 button.   

Under the 

Gas Type

 text click 

Change

 to change the gas type. Select the  proper gas  

type from the menu. The options are as follows: 

Argon, CO2, Helium, Nitrogen, 2% CO2/Ar,  

10% CO2/Ar, 15% CO2/Ar, 20% CO2/Ar, 25% CO2/Ar, 25% He/Ar, 

and 

3% 02/Ar

. Upon selecting  

a gas mixture, the page will return back to the Gas Setup page. 

▶ Change the Cylinder Capacity by pressing the 

Change

 button under Cylinder Capacity.  

The cylinder capacity options are configured on the keypad. A capacity from 1 – 500  

CF (1 – 15,000 liters) can be established. The number entered will be in the selected  

units (cubic feet if imperial and  liters if metric) If using bulk gas select the 

Bulk

 option.  

Upon selecting an option, the screen will return to the 

Gas Setup

 page. Click the backwards  

arrows once the gas type and cylinder capacity have been configured.

Figure 6

Figure 5