WireCrafters
Double Hinge Door
INSTALLER NOTES
1.
Component parts attach using self-drilling screws. Use variable speed screw gun with adjustable
clutch or depth locating nose piece. Use care not to over tighten and strip threads. DO NOT USE
IMPACT TYPE GUNS. Securely clamp part in place before attaching with self drilling screws.
2.
The dimensions shown on this page are from the floor to the bottom of the part for standard
height 6’ 11-3/4” door opening with 3-1/4” sweep space. Use worksheet on page 29 to calculate
component locations for non-standard door opening heights or sweep spaces.
3.
Partition wall should be set up and anchored to floor, with posts plumb before attempting to
install doors.
Double Hinge Door
Install transom panel (A) at top of door opening, check opening width at floor, and anchor posts to floor.
Check that posts are plumb and opening is square.
a.
Some doors may have a header tube in lieu of transom panel.
2.
Attach hinges (B) to door posts (C). See Fig.1 & 2 page 8 for swing out or page 7 for swing in.
a.
If necessary remove lower two 3/8” x 3” panel mounting bolts and replace with corner bolts.
Cut off and file smooth any protruding bolt threads.
b.
Stock door (3-1/4” sweep sp.), locate bottom of hinge 7-1/4”, 43-1/8”, and 79” from floor
3.
Mount door panels (D) & (K) to hinges (B) with 3/8” x 1” bolts (set sweep sp at 3-1/4” for stk dr).
4.
Attach pick plate (E) to door panel (D) Fig.1for swing out door, or (K) Fig.2 for swing in door.
a.
Locate bottom of plate 31-7/8” from floor for stock door.
5.
Install cylinder lock (if applicable) See page 6.
6.
Mark location of cane bolt on floor and drill 5/8” diameter round hole in floor surface
approximately 1-1/2” deep.
7.
If door has header tube, locate and install chain bolt receiver with two self drilling screws. See
Fig.3.
