WireCrafters
Barrier Hinge Door Inside Swing Right Hand Shown
INSTALLER NOTES
:
1.
Component parts attach using self-drilling screws. Use variable speed screw gun with adjustable clutch
or depth locating nose piece. Use care not to over tighten and strip threads. DO NOT USE IMPACT
TYPE GUNS. Securely clamp part in place before attaching with self drilling screws.
2.
The dimensions shown on this page are for standard physical barrier hinge doors 5’-0” tall with a
sweep space of 1’-0”. Use worksheet on page 29 to calculate component locations for non-standard
door opening heights or sweep spaces.
3.
Partition wall should be set up and anchored to floor, with posts plumb before attempting to install
doors.
Physical Barrier Hinge Door Inside Swing
1.
Check opening width at floor, and anchor posts to floor.
a.
Check that posts are plumb and opening is square.
2.
Attach hinges (B) to door post (C) using two self drilling screws per hinge.
a.
Note hinge placement offset detailed in Fig.1 and install tip in Fig.2.
b.
If necessary, remove two 3/8” x 3” panel mounting bolts, and replace with corner
bolts. Cut off and file smooth any protruding bolt threads.
3.
Attach door panel (D) to hinges with two 3/8” x 1” bolts and nuts per hinge.
a.
Set desired sweep space (12” for stock doors).
4.
Attach pick plate (E) to door post (F) using four self drilling screws.
a.
Note pick plate position offset detailed in Fig.1.
b.
Bottom of pick plate installs 32” from floor for stock doors.
5.
Attach cylinder lock receiver (G) to door post (F) with two self-drilling screws.
a.
Rolled side of receiver installs to face side of partition.
b.
Bottom of receiver installs 38-1/2” from floor for stock doors
6.
Install cylinder lock (if applicable). See page 6.
7.
Check operation of door, adjust as needed.
