WireCrafters
Hinge Door Inside Swing Right Hand Shown
INSTALLER NOTES
:
1.
Component parts attach using self-drilling screws. Use variable speed screw gun with adjustable
clutch or depth locating nose piece. Use care not to over tighten and strip threads. DO NOT USE
IMPACT TYPE GUNS. Securely clamp part in place before attaching with self drilling screws.
2.
The dimensions shown on this page are from the floor to the bottom of the part for standard height
6’ 11-3/4” door opening with 3-1/4” sweep space. Use worksheet on page 29 to calculate
component locations for non-standard door opening heights or sweep spaces.
3.
Partition wall should be set up and anchored to floor, with posts plumb, before attempting to install
doors.
Hinge Door Inside Swing
1.
Install transom panel (A) at top of door opening, check opening width at floor, and anchor posts to
floor. Check that posts are plumb and opening is square.
2.
Attach hinges (B) to door post (C) using two self drilling screws per hinge.
a.
Note hinge placement offset detailed in Fig.1 and install tip in Fig.2.
b.
If necessary, remove lower two 3/8” x 3” panel mounting bolts, and replace with corner
bolts.
c.
Stock Doors (3-1/4” sweep sp.), place bottom of hinge 7-1/4”, 43 1/8”, and 79” from floor.
d.
Cut off and file smooth any protruding bolt threads.
3.
Attach door panel (D) to hinges with two 3/8” x 1” bolts and nuts.
a.
Set desired sweep space (3-1/4” for stock doors).
4.
Attach pick plate (E) to door post (F) using four self drilling screws.
a.
Note pick plate position offset detailed in Fig 1.
b.
Bottom of pick plate installs 35-1/8” from floor for stock doors.
c.
If necessary, remove two 3/8” x 3” panel mounting bolts and replace with corner bolts. Cut
off and file smooth any protruding bolt threads.
5.
Install cylinder lock (if applicable). See page 6.
6.
Attach cylinder lock receiver (G) to door post (F) with two self-drilling screws.
a.
Rolled side of receiver installs to face side of partition.
b.
Bottom of receiver installs 41-5/8” from floor for stock doors.
7.
Align padlock lug (H) with door padlock lug on door (D) and attach to post (F) with two self
drilling screws.
8.
Check operation of door, adjust as needed.
