WireCrafters
Dutch Door Outside Swing Right Hand Shown
INSTALLER NOTES
:
1.
Component parts attach using self-drilling screws. Use variable speed screw gun with adjustable
clutch or depth locating nose piece. Use care not to over tighten and strip threads. DO NOT USE
IMPACT TYPE GUNS. Securely clamp part in place before attaching with self drilling screws.
2.
The dimensions shown on this page are from the floor to the bottom of the part for standard height
6’ 11-3/4” door opening with 3-1/4” sweep space. Use worksheet on page 29 to calculate
component locations for non-standard door opening heights or sweep spaces.
3.
Partition wall should be set up and anchored to floor, with posts plumb before attempting to install
doors.
Dutch Door Outside Swing
1.
Install transom panel (A) at top of door opening, check opening width at floor, and anchor posts to
floor. Check that posts are plumb and opening is square.
2.
Attach hinges (B) to door post (C) using two self drilling screws per hinge. Note offset detailed
in Fig.1 and install tip Fig.2.
a.
Stock door (3-1/4” sweep sp.), locate bottom of hinge 7-1/4”, 36-13/16”, 49-7/16” and 79”
from floor. If necessary remove 3/8” x 3” panel mount bolt and replace with corner bolt, cut
off and file smooth any protruding bolt threads.
3.
Attach door panels (D) & (I) to hinges with two 3/8” x 1” bolts per hinge,
a.
Set sweep space under lower door panel (3-1/4” for stock doors).
b.
Set 5/8” gap between door panels.
4.
Install cylinder lock (if applicable). See page 6.
5.
Attach receiver (G) to door post (F) using two self drilling screws.
a.
Rolled side of receiver installs to face side of partition.
b.
Bottom of receiver installs 35-3/4” from floor for stock doors.
c.
If necessary, remove one 3/8” x 3” panel mounting bolt from top of lower panel and replace
with corner bolt.
d.
Cut off and file smooth any protruding bolt threads.
6.
Align padlock lug (H) with padlock lug on door (D) and attach to post (F) with self drilling screws.
7.
Attach shelf (J) to top of door panel (D) with two 3/8” x 1” carriage bolts.
8.
Check operation of door, adjust as needed.
