TROUBLESHOOTING
73
Solution
Trouble
Possible Cause
Refer to "Display and Remaining Battery Amount" on P. 50 to charge the watch.
Charging
the watch
The stopped watch was
exposed to adequate light
for a longer time than "the
time required for fully
charging the watch,"
however, it does not resume
its normal one-second
interval movements.
Button
operation
Display
Others
Buttons or crown
cannot be operated.
Contact the retailer from whom the watch was purchased.
Blur on the dial glass
persists.
Small amount of water has got
inside the watch due to deterioration
of the gasket, etc.
Nothing is displayed.
The energy stored in the watch runs
low.
※For the solutions of troubles other than the above, contact the retailer from whom the watch was purchased or the SEIKO CUSTOMER SERVICE CENTER.
Reset the built-in IC. For details, refer to "How to Reset the Built-in IC" on P. 74.
Place the watch where it can be exposed to an adequate light source. Make sure that the manner of
lighting the watch is not altered while the watch is being charged.
The light is too weak or the manner
of lighting the watch has been
altered while the watch is being
charged.
The built-in IC has fallen into an
unstable condition.
Summary of Contents for W36 Series
