20
The screen shows start time and end time of recorded data.
Overwrite Setting
Click(
) Overwrite Setting button and the following screen will appear.
You may set for beeping or notifying messages that notify the used percentage of disk.
Check Disk Overwrite and you may activate the overwrite function.
This function makes restart the recording from the beginning when the HDD is full. The previous recorded data will be
erased from the first one. Following icon will display in bottom of live mode
.
①
Uncheck (
□
) Disk Overwrite, recording will stop automatically when the HDD is full.
②
At the Overwrite mode, when HDD capacity is full,
icon will appear, and the recording is going on,
will appear.
③
If you change this setting, the warning message will appear. Then click (
)
‗confirmation‖ button and you may change
the setting.
If you check (
) Disk full notify item, the warning message will appear as the used amount of disk.
①
Used
You may set the certain value of HDD usage for notification. It will notify at that point. The values are from 50 ~ 100%.
②
Alarm-Out
The Alarm-out will happen at the used amount of HDD which is specified at Used.
③
Beep
Check (
), the warning sound will happen at the used amount of HDD which is specified at Used.
④
Blink Message
Check (
), the warning message ―Disk Used(xx%)!‖ will appear on the OSD.
Clear All Data
Use to delete or purge all normal recorded data from database. Please follow the procedure below.
①
Click (
) Clear All Data frame.
②
When a dialogue box asking ―Remove All Data?‖ shows, choose ‗OK‘.
③
Then, Progress window will appear and the process starts.
④
When all data are deleted, a dialogue box asking ―Are you sure to reboot?‖ will pop up.
⑤
Choose ‗OK‘ to delete all the recorded data as well as System Log.
When you finish all the necessary inputs to SYSTEM menu, please click (
) ‗OK‘ on the bottom to go back to SETUP
screen.
(NOTE)
This might take a while to completely delete all data. In case of 80GB HDD for example, it takes about 90 seconds.
(NOTE)
For more specific setting about Alarm-out, use Setup>DEVICES>Alarm Out.
(NOTE)
Notify setting does not affect saving the recorded data. It only gives notification, and keep recording until hard disk is full.
