2-5 Hardware Installation
The RedFire 200e is a radio device, so it is susceptible to common causes of interference that
can reduce throughput and range. Follow these basic guidelines to ensure the best possible
performance:
¾
IF there is any other 2.4GHz RF device deployed around the outdoor radio, try to set the
channel to the non-overlapping one.
¾
Install the bridge at a height sufficient place where structures, trees, or hills do not obstruct
radio signals to and from the unit. A clear line-of-sight path can guarantee the performance
of the RF link.
Site Surveys
Clear and flat area provide better RF range and data rate, on the contrary, physical
obstructions such as trees, electric tower, hills or buildings can reduce the performance
of RF devices. Do not deploy your radios in the location where there is any obstacle
between the antennas.
Configure and verify the RedFire 200e operations first before you mount the radio in a
remote location.
RedFire 200e Radio User Manual
Chapter 2 Hardware Installation
Hardware Installation
15
Summary of Contents for RedFire 200e
Page 1: ......