To activate the Point-to-Point Bridge mode please do the following:
1.
Enable WDS mode for both outdoor radios:
¾
Configure both radio1 on LAN Segment A and radio2 on LAN Segment B in
Point-to-Point Bridge mode
.
¾
Enter Mac address of radio 2 into the Remote MAC Address field of radio 1.
¾
Enter Mac address of radio 1 into the Remote MAC Address field of radio 2.
2.
Enable Wireless Client Association:
¾
If enabled, your outdoor radio is functioning as a regular Access Point, which
can provide the link services to wireless clients. Then, wireless clients can
communicate with other wireless clients that are located in different LAN
Segments.
¾
Verify that radio1 and radio2 are both configured in the same LAN network
address range as wireless clients with which associated.
¾
Make sure that Mode, SSID, Channel and encryption settings are set the same
for both of your WDS-compliant Access Points.
If you complete the settings, please click on “apply” icon for the changes to take
effect.
RedFire 200e Radio User Manual
Chapter 3 Configuring the 802.11g Radio
Wireless Setup
36
Summary of Contents for RedFire 200e
Page 1: ......