When the distance is too long or there is obstruction there between two points, you
may need a Repeater in your net work. Please follow the steps below to activate the
Repeater with Wireless Client Association:
1. Enable WDS mode for all the outdoor radios:
¾
Configure radio 1, radio 2, and radio 3 in
Repeater with Wireless Client
Association mode
.
¾
Enter Mac address of radio 1 and radio 3 into the Remote MAC Address field of
radio 2.
¾
Enter Mac address of radio 2 into the Remote MAC Address field of radio 1 and
radio 3.
If you complete the settings, please click on “apply” icon for the changes to take
effect.
Under Repeater Bridge mode, you can extend this repeater bridge by adding
additional RedFire 200e for each additional LAN Segment.
Enable Smart WDS
If this feature is selected, a WDS Service Group ID is required and must be the same
with the ID of other remote outdoor radios. You can input up to 32 characters. After
you complete the settings, please click on “Apply” for changes to take effect.
Wireless Parameters
These parameters can be changed if needed, but the default advanced setting usually
work well. It is recommended that you keep all these values in factory default.
Chapter 3 Configuring the 802.11g Radio
Wireless Setup
39
RedFire 200e Radio User Manual
Summary of Contents for RedFire 200e
Page 1: ......
