1] Fit the bottom edge of the battery pack into the holes of
the transceiver cabinet bottom�
2] Push the battery pack down to the transceiver aluminum
chassis till the end clicks�
1] Connect the jack of AC adaptor to the DC input
socket on side of the desktop charger�
2] Plug the AC adaptor into the power outlet�
3] Insert the radio into the charger�
4] The radio will re-charge in around 2 hours�
Fitting & Removing the Battery Pack
•
To Install the battery pack
•
To remove the battery pack
Press the release lever of the battery pack while levering the battery pack away from
the transceiver body. Note: It is normal for this lever to be firm.
Charging the Battery Pack
A Key: Emergency*
B Key: PTT Press To Talk
C Key: Lone Worker*
D Key: Monitor
Remove the radio from the charger
when the battery is fully-charged
Make sure the radio is turned off while charging�
2
