Wireless Pacific X10DR CLASSIC, User Manual

15

Typically the X10DR’s default audio levels settings are suitable for a variety 
of today’s professional mobile radios, when used with the Wireless Pacific 
model  specific  XCA  series  X10DR  cable  Adaptors.  However  we  would 
suggest when first installing your X10DR system you may need to adjust the 
transmit and receive audio levels  using the field programmer for optimum 
audio quality.

TRANSMIT: 
To verify the transmit microphone level is set correctly, first talk on the host 
mobile radios curly cord microphone while monitoring the communication 
with another radio or communications analyzer.  Speak in a normal voice 
about 2-3cm (1”) from the microphone, now do the same with the X10DR 
Secure Microphone; the audio levels should be about the same. If the 
Secure Mic audio is lower or is distorted you will need to adjust the level by 
reprogramming the device with the field programmer so that levels and 
audio quality are about the same.

RECEIVE: Using another radio, talk into its microphone while listening to 
the audio received thru the X10DR speaker. It should be loud and clear 
with  the  X10DR  volume  turned  up  near  maximum.  If  not,  use  the  field 
programmer to adjust to the desired level. On some model radios, the 
radio’s volume control effects the Rx audio that is passed to the X10DR, for 
these situations first set the host mobile to a normal listening level before 
then programming the receive audio level for desired loudness. In such 
cases, users should note if you adjust the host mobile radio’s audio up or 
down the X10DR speaker audio will be effected likewise.

IMPORTANT

See the Service Section for use of the field programmer.

Each X10DR Secure Wireless Microphone is uniquely connected to a 
specific  gateway  mobile  charger  in  the  factory.  This  ensures  that  all 
communications between the two units are secure and cannot be 
compromised or interfered with by a third party. In the event of a  Secure 
Wireless Microphone being lost, it can be permanently disconnected from 
the X-Ponder mobile charger by connecting with a new replacement unit.

How to pair: hold the secure mic while pressing both the blue volume 
controls  until  the  blue  LED  flashes  and  the  secure  mic  beeps  (after  5-8 
secs). Now place the speaker mic back into the gateway cradle. After a 
few seconds the secure mic will sound a confirmation two tone and the 

Audio adjustments

Device Pairing