R01.i
RT System 2 v2.3 Deployment Guide
63
© 2010-2014 Wireless Seismic, Inc. All rights reserved.
3. Backhaul
Setting up the Backhaul
b
Attach the cables to the bottom end of the
Bullet radios.
Ź
Assemble the connector for the radio as
shown in the image to the right:
Ź
Plug the Ethernet connector into the
radio.
Ź
Screw the large coupler into the base of
the radio. Hand-tighten only.
Ź
Push the rubber grommet into the base
of the large coupler.
Ź
Screw the end cap on the large coupler.
Hand-tighten only.
c
Tighten the clamps on the Bullet radios.
Ź
Verify that the armored cables attached
to the antennas are straight and not
twisted.
Ź
Position the line radio so the armored
cable is not pulling on the antenna.
Ź
Tighten the cable clamp.
19 Set up the LIU:
Ɣ
Ground the LIU – Verify that the LIU is
grounded. Attach a ground wire to the case,
and to a nail that is driven into the ground.
Attach the LIU ground wire and the Surge
Protector ground wire to the same nail.
Table 3–10 How to Set Up the Backhaul
Step
Image
