Revision 4
Author: Anders Zellén
Wireless Solution Sweden Sales AB
Stureparksvägen 7
– 451 55 Uddevalla – Sweden
+46 522 511 511 Tel. +46 522 440 885 Fax.
Wirelessdmx.com sales@wirelessdmx.com
14(23)
14/11/2014
7.1.5 Status Indicator LED
The Status LED indicates the current status of the wireless connection and the presence of
DMX data. The status is valid after start-up process has finished after ~1.7s (worst case) from
power on
The LED is active high, and should be connected between J1:5 and ground, for example J1:7
via a series resistor.
The LED output can deliver a maximum of 15mA. For the average LED a series resistor of
330ohms will work well.
The indications below are valid during steady state, that is in normal running mode after the
boot loader has finished.
/ “Off” denotes a dark LED and / “On” denotes a lit LED.
7.1.5.1
LED Indication - Receiver:
7.1.5.2
LED Indication - Transmitter:
Continuously Off = not assigned to a transmitter
On 900ms / Off 100ms = assigned to a transmitter, but no DMX present
Continuously On = assigned to a transmitter and DMX present
On 100ms / Off 100ms = link to transmitter lost or linking to transmitter
On 900ms / Off 100ms = no DMX present
Continuously On = DMX present
On 100ms / Off 100ms = linking receivers
On 500ms / Off 500ms = unlinking all receivers