9
WPS-350-BUL-A Installation Manual
© 2013 Wirepath Surveillance
4. Fine-Tuning Camera Adjustments
The Camera is equipped with a BNC Test Port that allows for local Analog
Video output for adjusting positioning, zoom, and focus.
The camera is supplied with a BNC Test Adapter that allows for viewing the
output of the camera on a monitor or the WPS-CCTV-TESTER (not included).
Use this connection to adjust the camera directly from the installed location.
A. Remove the plate located at the rear of the Cameras just before the
Cameras base to access the BNC Test Adapter connection.
B. Connect the BNC Test Adapter to the Camera.
C. Connect the BNC on the adapter to a monitor or WPS-CCTV-TESTER video in.
D. Adjust the Cameras Rotation, Swivel, and Angle as defined in step 1 and
secure the set screws using the supplied 3mm Allen key.
E. Adjust the Cameras Zoom (closest to the lens) using the supplied 3mm
Allen key.
F. Adjust the Cameras Focus (furthest from the lens) using the supplied 3mm
Allen key.
G. Once the Zoom and Focus are adjusted, disconnect the BNC Test
Adapter and replace the plate removed in step 4-A.
Adjust Zoom
Adjust Focus
BNC Test Adapter
Connection
