Limited Lifetime Warranty
This Wirepath Product has a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in
material or workmanship under normal conditions of use. This warranty shall not apply to products that have been abused, modified, or disassembled.
Products to be repaired under this warranty must be returned to SnapAV or a designated service center with prior notification and an assigned return
authorization number (RA).
Lifetime
WP-ONE-DOOR-XX
Dimensions
14
17.91"W x 15.96"H x 2.94"D
20
17.91"W x 21.96"H x 2.94"D
28
17.91"W x 29.96"H x 2.94"D
40
17.91"W x 41.96"H x 2.94"D
Hardware Pack
1
2-Position Mounting Platform
14
1
20
1
28
1
40
2
Material
White ABS Textured Plastic
Dual Locking
Yes
UL Listed Material
94V-0
Installation
Tools Needed:
5mm Allen Wrench
#2 Phillips Screwdriver
1.
Locate the desired position over the installed enclosure, leaving enough clearance for the door to swing
open in the desired direction. To reverse the swing direction, skip to Swing Direction Reversal below
prior to installation.
2. To mount, remove the door first. Unlatch and swing the door open before pulling upward to remove.
3. Ensure the door base is level, and drive a minimum of 4 (14”, 20”), or 6 screws (28”, 40”) into the drywall
or plywood through the Surface Mounting Holes of the door base.
4.
Reinsert the door’s hinges onto the hinge pins, orienting it to swing in the desired direction. To reverse
the default direction, follow the directions below.
Swing Direction Reversal
ATTENTION:
For best practice, determine the direction you would prefer the door to swing prior to installation.
Reversing the hinges requires access to the rear of the door base.
1.
Open the door, then slide it up and off all hinges.
Size
14 in.
20 in.
28 in.
40 in.
No. of Hinges
2
2
3
4
2. Remove hinge bolts from the rear of the door base with a 5mm Allen Wrench. Turn the hinges laterally
so that the hinge pins face the outside of the enclosure.
3. Remove the two screws from the hinge pin receiver bracket on the door with a screwdriver. Swap the
hinge pin receiver over to the adjacent slot.
4.
Slide the door back onto the hinges. Continue on to reverse the direction of the latch.
Latch Reversal
1.
To remove the door latch (F), remove the clamp with a #2 Phillips screwdriver, and slide the latch out
of the door.
2. Rotate the latch mechanism 180° and re-install into latch opening.
3. Loosen the latch plate screw, located behind the latch, and rotate the latch 180° so that it faces the slot
in the door. Tighten screw back down once it is in the correct position.
Rev: 141212-1400
www.snapav.com Support: 866.838.5052
Front
Rear
