Page 4 of 15
repeated matings.
A:
If the bulkhead adapter sleeve is made from phosphor-bronze, some of
the metal is probably rubbing off on the connectors.
3.0
INSTALLATION
3.1
Unpacking
Inspect the shipping boxes for any obvious damages.
Unpack the unit from all packaging boxes.
Inspect the appearance of the unit for any shipping damages.
Document and inform the shipping company and your local representative,
as seen in section 1.2, of the damages.
Save the shipping boxes and their inserts for any future reshipment for
upgrade or repair.
NOTE: In the event of a reshipment back to the manufacturer, any additional
damages caused by not using the original boxes will be considered
responsibility of the customer.
3.2
EDFA Mounting and Power Connection
1.
Place the unit into a 19-inch wide rack or cabinet. Make sure to leave a
1.75-inch (about 4.5cm) space above and below the unit.
2.
According to the design request, HA5800A series 1550nm EDFA can work
under 0°C~50°C (32°F~122°F) temperature range. We recommend 25°C
(77°F) environment temperature.
Humidity not bigger than 95%(under non-coagulation condition). If
necessary, the equipment should keep the suitable temperature & humidity
in the restrained scope. We recommend to operating in the environment
without dust.
3.
Equipment powered by AC or steady voltage DC. In both of AC & DC, AC
is the chief power supply.
Request of power supply:
AC input
94-245VAC, 50-60Hz
DC input
36-60VDC, floating
Power consumption
Maximum 50W
4.
The DC power supply of the equipment must be the SELV supply
stipulated as CAN/CSA C22.2 No.950-95 standard.
5.
The machine should have good grounding, grounding resistance<4Ω.
According to the international standard, 220V plug in adopts tri-wire rule,
