SAGE L150m
WISDOMAUDIO.COM
10
Making the L150m Connections
As with any system, you should make changes to the connections only when the power
is turned off to avoid any chance of inadvertently causing a problem (such as a short-
circuit).
Note:
The Wisdom Audio L150m is a tri-amplified speaker that requires
three
sets of
speaker wire to each location rather than the usual two. One pair of connections is for
the planar magnetic module, whereas the woofer module uses two sets of connections,
one each for six of the 12 woofers.
We recommend using heavy-gauge speaker wire, the gauge will vary dependent on your
speaker run length. Please consult an authorized dealer to determine what gauge would
be best for your application.
For the purposes of this manual, we will assume that you have already connected the
SC-2/3 System Controller as per the instructions found in its manual. As such, you
should have signal coming from your source component(s) to a preamp/ processor, and
then on to the SC-2/3; following the SC-2/3, the signal is split into low and high sections,
with the low section going to one or more Wisdom Audio SA Series amplifiers, and the
high section going to another amplifier, which will drive the planar magnetic panels.
Connect the outputs of your Wisdom Audio SA-series amplifier to the appropriate
woofer sections, taking care to get both the channel assignments and the polarity
correct. Connect the positive (+) terminals on the SA Series amplifier to the positive (+)
terminals for the woofer on the loudspeaker; likewise, connect the negative (–)
terminals on the amplifier and the speaker, respectively.
Next, connect the outputs of your chosen amplifier for the midrange/treble to the Sage
L150m planar sections in a similar fashion, taking care with all three channel
assignments and polarity.
Care & Maintenance
To remove dust from the front of your L150m, use a feather duster or a lint-free soft
cloth. Never attempt to clean the drivers themselves.
