SAGE L150m
WISDOMAUDIO.COM
7
Unpacking and Installing the L150m
The
Wisdom Audio Sage L150m
on-wall speaker is a substantial piece of equipment.
Please exercise caution when unpacking your L150m to ensure that you do not strain
yourself from its (perhaps unexpected) weight.
CAUTION:
Do not attempt to lift your L150m while bending or twisting from the waist.
Use your legs for lifting, not your back. Always stand as straight as possible and keep the
L150m close to your body to reduce strain on your back.
The speaker is shipped in a “telescoping” box (two five-sided boxes, one of which fits
snugly inside the other). Gently roll the box over so that its bottom is facing up. Then
carefully cut the tape along the bottom of the box on all four sides. Roll the box over
again so the bottom is on the floor and lift off the top. With one person at each end,
carefully lift the speaker out of the box and lay it on a soft surface (carpet or similar).
We do not recommend removing the grille on your new loudspeakers. The grille is an
integral part of the design; moreover, the planar magnetic film should never be
touched, as it is tensioned precisely at the factory. The grille plays an important
protective role as well as an aesthetic one.
After unpacking your L150m, keep all packing materials for future transport.
If you
need to ship your speaker, only the original, purpose-designed shipping carton is
acceptable. Any other method of shipping this product runs a significant risk of damage
to the speaker – damage that would not be covered by the warranty. (If you lose your
packaging and need
to ship your speakers, replacement packaging can be purchased
from Wisdom Audio.)
Proper Planar Placement for front L&R and Rear Surrounds
When using the L150m for front L&R and or Rear Surrounds the planar drivers should
always be placed on the inside as shown below in a front screen wall LCR example.
