SAGE P38m
WISDOMAUDIO.COM
6
We do not recommend removing the grille on your new loudspeakers. The grille is
an integral part of the design; moreover, the planar magnetic film should never be
touched, as it is tensioned precisely at the factory. The grille plays an important
protective role as well as an aesthetic one.
After unpacking your P38m, keep all packing materials for future transport.
If you
need to ship your speaker, only the original, purpose-designed shipping carton is
acceptable. Any other method of shipping this product runs a significant risk of
damage to the speaker – damage that would not be covered by the warranty. (If
you lose your packaging and need
to ship your speakers, replacement packaging
can be purchased from Wisdom Audio.)
Mounting the P38m on the Wall
The mounting bracket that mounts to the wall is shipped attached to the back of the
loudspeaker. It is removed by pulling “down” on it relative to the end of the
speaker that will be “up” when installed on the wall. (Note that for horizontal
center channel speakers, this means the bracket is pulled
across
the narrow
dimension of the speaker.)
It is recommended to place a screw into every open
mounting hole so to avoid the bracket possibility resonating once the speaker is
mounted to the wall.
Please note that this guide assumes the wall surface is flat. If not, shims must be
applied to the rear of the mounting bracket so that the mounting bracket is
uniformly secured to the wall and flat (not distorted). The mounting steps are as
follows:
1.
Locate the area with the two sets of high- and low-pass speaker cables
coming out of the wall.
2.
The inside face of the bracket assembly has arrows stamped into it
indicating which direction must be “up” when it is mounted on the wall.
Align the center screw hole in the mounting bracket next to the speaker
