18
4.2 Adjust the laser path
4.2.1
: Put a acrylic, paper or other transparent non-metal before the first reflecting mirror. Press “ Test light”. The
next step is adjusting the position of laser tube to make the laser ray in the center of the first reflecting mirror. Just
like the following picture,
z
1 .The first reflecting mirror.
z
2. The side of the laser tube that sends out laser beam.
z
The green line is the laser path.
Put a acrylic, paper or other transparent non-metal before the second reflecting mirror, press “Test light” on the panel,
adjust the screws on the first reflecting mirror to make the laser in the center of the second reflecting mirror.
z
1. The second reflecting mirror.
z
2. The first reflecting mirror;
z
3. The outlet of the laser tube;
z
4. The green line is the laser path;
¾
First step, move the laser head to the
top left corner
where the first and second reflector mirrors is nearest.
Put an acrylic, paper or other transparent non-metal before the second reflecting mirror, press “Test light”
on the panel to make a laser dot on the material, adjust screws of the first reflecting mirror to make the laser
dot in the center of the second reflecting mirror.
z
It is better put on gloves while adjusting the light path, in case
the laser shoot to hands;
