8
MAIN BODY ASSEMBLY
STEP 1
Prepare a solid
fl
at work surface. Lay the main
stove body on the work surface. Position the
stove so that the legs hanging off of the surface
approximately six inches.
STEP 2
Install the base as shown with the two (2) 7/16”
hex bolts, two (2)
fl
at washer, and two (2) lock
washer provided with your stove.
Note:
There is a
long end and a short end to the base. To ensure
stability of the stove, the long end must face the
front of the stove.
STEP 3
To install the hopper, place the stove upright on
the
fl
oor. Insert the hopper chute into the feed
tube as shown. Place torpedo level on the top lip
of the hopper. It will be sandwiched in between
the main heat shield and the hopper. Next make
sure the hopper is level with the stove and use two
(2) self-drilling screws to fasten the hopper to the
stove as shown.
CAUTION: Do Not over tighten the screws as this
could cause stripping of the screw threads.
Note:
Make sure you are working on a level work
surface. Hopper must be level with the stove; a
second set of eyes looking at the front of the stove
is a good idea.
STEP 4
Install the pellet slide as shown. The chute (
fl
at
end) will go in
fi
rst. The pellet slide will slide in and
seat at the bottom of the feed tube.
Caution! The appliance is very heavy. The assistance from a second person is strongly suggested. Please use
proper lifting technique when positioning the appliance for assembly and installation.
This chute must
tube and rest on
the bottom.
ITEMS NEEDED
1. One 1/2” opened ended wrench
2. One 7/16” open ended wrench
3. One 3/4” socket and ratchet wrench
4. Screw gun (cordless is recommended)
5. One 5/16” nut driver (extension is recommended)
6. One torpedo level
Chute
Feed Tube
