Page 7
CHAMELEON GN40
Installation guide
Caution
The mains voltage must match the rated input voltage of the unit
(230 VAC).
Connecting cable - Lay the cable so that no-one can trip over it.
- Lay the cable with a downward loop so that any water condensing on it can drip on
the floor instead of running into the unit.
Selecting the installation location
Excessive temperatures will reduce the operating lifetime of the unit.
Don't install the unit directly above or in the vicinity of radiators or heating
systems where it would be subjected to thermal radiation or oil vapours.
Moisture
Water dripping or splashing onto the unit will damage it. If there is condensation on the
unit, wait until this has evaporated before switching
the unit on.
Caution – danger!
In accordance with EN 60728-1, the satellite antenna system must comply
with the safety requirements with respect to grounding, potential
equalisation, etc.
Service work
Service work may be carried out only by qualified personnel. Always
disconnect the supply voltage before starting any such work.
Ambient temperature — Not greater than 50
°
C.
Thunderstorms
Avoid carrying out service work on the antenna system during thunderstorms.
Caution – danger!
Fuses may be replaced only by qualified personnel. Only fuses of the same
type and rating may be used.
Batteries
Do not throw exhausted batteries in the garbage. They must be disposed
of separately.
All of our packing materials (cardboard boxes, packing notes, plastic films
and plastic bags) can be recycled.
Safety and installation notes – please observe
