Wireless Self-powered 4 Button Switch
Catron IV
WARNING AND GUIDELINES!!!
DO NOT INSTALL DAMAGED PRODUCT!
This product has been properly packed
so that no parts should have been damaged during transit. Inspect to c
onfirm.
Any part damaged or broken during or after assembly should be replaced.
WARNING :
TURN THE POWER OFF AT THE CIRCUIT
BREAKER BEFORE WIRING
Required tools & supplies
INSTALLATION INSTRUCTIONS
Installation Steps
Read and follow all safety instructions!!
Do’s
Installation should be performed by
a qua
lified e
lectrician
Don'ts
Don't use outdoors
Installation shall be in accordance with
all applicable local and NEC codes
Avoid input voltage exceeding
maximum rating
Turn the power OFF at circuit
breakers before wiring
Don't dissemble the products
Observe the correct polarity of
output terminal
Electrostatic Discharge (ESD): ESD can damage product(s). Personal grounding
equipment should be worn during all installation or servicing of the unit
Do not stretch or use cable sets that are too short or are o
f insufficient
length
Do not modify the product
Do not mount near gas or electric heater
Do not change or alter internal wiring or installation circuitry
Do not use product for anything other than its intended use
WARNING: Risk of Product Damage
Screwdriver
Screws
Wall plates
Decide where you want to mount the rocker pad. The standard height for wall
switches is 49” or 125 cm on center
Remove the wall plate from the rocker pad assembly
Decide which of the two installation options is appropriate
A. Surface Mounted Installation
I. Using a level and a pencil, lightly mark 2 small dots to align the top edge of
the mounting plate.
II. Mark the mounting screw drill points.
Ensure optimal communications with other system components
Pick a convenient location, perhaps near a door where occupants enter and exit
Consider the construction materials in the space and remove the obstacles that
may interfere with RF signals
Verify that supply voltage is correct by comparing it with the product
information
Make all electrical and grounded connections in accordance with the National
Electrical Code (NEC) and any applicable local code requirements
All wiring connections should be capped with UL approved recognized wire
connectors
All unused wiring must be capped
WARNING - Risk of Electric Shock
Specifications
Type
Min
Max
Remarks
Power Supply
Electrodynamic harvesting
Operating Temperature
65
65
-25
-25
0
°C
°C
Storage Temperature
_
_
_
_
_
Relative Humidity
_
95
%
mm
mm
mm
Dimensions of
Double Rocker
_
_
_
25X50
in
in
in
mm
in
0.98x1.96
_
Non-condensing
L x W For each
of the 2 rockers
Dimensions of
Frame Insert
55X55
2.16x2.16
2.79x2.79
71x71
_
_
_
_
_
_
_
_
_
_
L x W
L x W
L x W
L x W
L x W
Dimensions of
Central Plate
Dimensions of
Frame
_
81x81
3.19x3.19
_
INSTALLATION AND QUICK START SHEET
Product Overview
Catron IV is a wireless self-powered 4 button switch that c
onfigu
res ON/OFF,
intensity, and correlated color temperature of an individual or group of luminaires.
It is a part of Lumos Controls ecosystem, which includes controllers, sensors,
switches, modules, drivers, gateways, and analytical dashboards.
TOP
TOP
