Dual-channel constant current LED driver
Ldrive 36W
WARNING AND GUIDELINES!!!
DO NOT INSTALL DAMAGED PRODUCT!
This product has been properly packed so that
no parts should have been damaged during transit. Inspect to confirm. Any part
damaged or broken during or after assembly should be replaced.
Required Tools & Supplies
Read and follow all safety instructions!!
Method of installation varies based on the luminaire manufacturer
Do’s
Installation should be performed by a
qualified electrician
Dont's
Don't use outdoors
Installation shall be in accordance with
all applicable local and NEC codes
Avoid input voltage exceeding
maximum rating
Turn the power OFF at circuit breakers
before wiring
Don't dissemble the products
Observe the correct polarity of output
terminal
-
Check the polarity of the output terminals
The LED wiring should be kept as short as possible to ensure good EMI behavior
Sensor integration can be done using the 0-10V input and 12V auxiliary output
Secondary switching is not permitted
Incorrect wiring can damage the LED module
Installation steps
Wiring instructions
Turn the power off at the circuit breaker before wiring
Install the driver into the fixture using the screws
INSTALLATION AND QUICK START SHEET
PRODUCT OVERVIEW
Ldrive 36W is a dual-channel constant current LED driver with programmable output
current. It is a part of Lumos Controls ecosystem which includes controllers, sensors,
switches, modules, drivers, gateways, and analytical dashboards.
Prior to mounting, turn on power and test
connection to ensure system is operating properly.
Turn off power again before mounting.
Specifications
Value
Remarks
Input voltage
120-277VAC
_
_
_
Input current
0.35A
0.5W
Power consumption
Typical efficiency
85%
120VAC/50Hz/full load
120VAC/50Hz/full load
Power factor
0.95
Output current
450-800mA
800/700/550/450
Adjusted by dip switch
Output voltage
42VDC
_
Conductive
Ambient temperature
-20 to 45ºC(-4 to 113ºF)
@Life-time 50,000h
Turn on delay
<500ms
Lifetime
50,000h
@50ºC
Tx power
8dBm
Dimensions
324 x 30 x 21mm
(12.8 x 1.2 x 0.8in)
L x W x H
THD
<15%
120VAC/50Hz/full load
INSTALLATION INSTRUCTIONS
WARNING :
TURN THE POWER OFF AT THE CIRCUIT
BREAKER BEFORE WIRING
Electrostatic Discharge (ESD): ESD can damage product(s). Personal grounding
equipment should be worn during all installation or servicing of the unit
Do not stretch or use cable sets that are too short or are of insufficient length
Do not modify the product
Do not mount near gas or electric heater
Do not change or alter internal wiring or installation circuitry
Do not use product for anything other than its intended use
WARNING: Risk of Product Damage
Dip Switch
Configuration
Power the driver connecting the Line and Neutral wires from the mains supply
Connect Warm, Cool channel from the LEDs to the driver
Head:
CSK Slotted
Length
38mm
8.3mm
3.7mm
Head Diameter
Screw Diameter
Screwdriver
Screws
Verify that supply voltage is correct by comparing it with the product
information
Make all electrical and grounded connections in accordance with the National
Electrical Code (NEC) and any applicable local code requirements
All wiring connections should be capped with UL approved recognized wire
connectors
WARNING - Risk of Electric Shock
Dip Switch
12V
Aux
WW+
WW-
CW+
CW-
ADC
0-10V
GND
N
L
PE
LDRIVE-36W
L
N
SENSOR
LED
ON
1
2
Dip Switch
lout
1
-
ON
ON
ON
800mA
700mA
550mA
450mA
ON
-
-
-
2
