16
lever and tighten securely to 6 to 8N.m whilst continuing to apply the brake lever. (N.B. use
of a thread locking compound is recommended on the caliper fixing screws).
Warning:
If you are unsure about any part of the brake installation process you should seek
advice from a Wisper service center or qualified mechanic.
Caution:
The pads and rotor must be kept clean and free from oil or grease based
contamination. If the pads become contaminated, you must discard them and replace them
with a new set. A contaminated disc should be cleaned with a proprietary brake cleaning
solution.
3.7
Stem and handle bar clamps
3.7.1
Your bike has been fitted with an adjustablehandlebar and stem clamp that allows youto
change the angle and height of the bars to find the most comfortable riding position.
3.7.2
The handlebars can be adjusted before you use the bike by slackening the clamp in the
middle of the handle bars. Once a comfortable position is achieved, securely tighten the
clamp and lock into position.
3.7.3
To alter the height of the handlebars, slacken clamp at the front of the stem. Slide the
handlebars to the requires position and securely clamp into position making sure there is no
movement in the clamp or handle bar stem.
