Product: Eleganza 1
Version: 01
30/68
9.3
Status Faulty Battery
The battery is regarded as faulty if at least one of the following conditions applies:
Battery charging constantly
Low voltage on battery
Low charging current of battery
Status “faulty battery” is indicated:
By the battery status indicator being constantly lit.
A fault battery status can be cancelled by pressing the STOP button.
Battery status data is saved to the Linis system and written to the “Blackbox”.
9.4
Status Discharged Battery
The battery is regarded as discharged if the following condition is met:
Defined decrease of voltage depending on discharging current
Status “discharged battery” is:
Status is indicated by the battery status indicator flashing quickly.
The electric CPR position is the only possible position.
This status will be cancelled automatically when the bed switches to sleep mode.
9.5
Removing the Bed from Service
How to remove the bed from service:
Disconnect the bed from the mains.
Disconnect the ground wire.
Deactivate the battery (see Deactivating the Battery).
Remove accessories.
To prevent damage during storage:
Pack or cover the bed and accessories.
Ensure storage conditions are the same as the operating conditions.
9.6
Deactivating the Battery
To avoid damaging the bed and the environment during storage:
Deactivate the battery on the supervisor control panel.
To deactivate the battery on the supervisor control panel:
Disconnect the bed from the mains.
Disconnect the ground wire.
Activate the keypad by pressing the GO button on the supervisor control panel.
Press the Thigh Rest Up + Thigh Rest Down + Trendelenburg Position buttons at the same time and hold
them for three seconds.
The battery is deactivated.
NOTE: Try some functions to ensure the battery is deactivated.
