MCR41/MCR42 User Manual
18
Headphones
(only for
Cycle through menu’s with
up/down
arrow to get your
desired configuration then confirm with
SEL
.
Volume:
It is possible to set the desired output level from
Max
(+6 dB) to
min
(-24 dB) in 1 dB step.
Balance:
with this parameter it’s possible to balance the
delta of the volume between Left and Right on the
headphones (it’s possible to set up to 12dB between L/R).
For example: if volume is set to 0dB and Balance to R+4, in
the HP output, L will be -2dB and R will be 2dB.
RX mix:
if the parameter
RX sel
is set to
Rx1+Rx2(L+R)
, it’s
possible to balance the delta of the volume between RX1
and RX2 (it’s possible to set up to 12dB between RX1/RX2).
For example: if volume is set to 0dB, Rx signal to
Rx1+Rx2(L+R)
and RX mix to Rx1+6, in the HP output, RX1
will be at 3dB and RX2 will be at -3dB.
RX sel:
Left and right channel of stereo jack can be mapped
respectively on RX1, RX2 or on RX1+RX2.
Signal:
If set to LINE, on the headphones there is the same
signal of the output LINE. If set to TSQ>LINE and the
is enable (Tone Squelch ON or ADV), on the
headphones it is possible to hear the signal even when the
Tone Squelch is not detected.
Example: if Volume= 0dB & Balance= R+4
RX1
RX2
DSP
L=-2dB
R=2dB
Δ=4dB
0dB
2dB
-2dB
Delta is centered on the set
Volume (in this case 0dB)
L
R
0dB
3dB
-3dB
Delta is centered on the set
Volume (in this case 0dB)
RX2
RX1
(RX1@3dB)+(RX2@-3dB)
(RX1@3dB)+(RX2@-3dB)
RX1
RX2
DSP
Example: if Volume=0dB, RX sel=
Rx1+Rx2(L+R) & RX mix= Rx1+6
+
L
R
Δ=
6dB
Δ=
6dB
Summary of Contents for MCR41
Page 9: ...MCR41 MCR42 User Manual 8 Advanced...
Page 43: ...MCR41 MCR42 User Manual 42...
