5
ON & RF Led Indicators (Firmware rel. v1.2)
ON
RF
DISPLAY*
WHEN
MEANING
p
o
w
er u
p
p
h
as
e
red
off
on
when the receiver is
power on, during the
power up phase
the receiver is not ready to
use, wait the status menu on
display
red
off/on
on
when the receiver is
power on, after the
power up phase
an error has occurred during
the boot phase. Power on
again the receiver. If the led
indicator ON continues to
remain red, contact Wisycom
repair service
red
red
on
when the receiver is
power on, during a
frequency change
phase (see Gr-Ch or
Frequency menu)
the PLL is not locked on the
select frequency, wait for
lock ( about 1second or less)
Tu
n
in
g
p
h
as
e
fixed
green
red
on
after the tuning
phase, no transmitter
is received
the receiver is ready to use,
the batteries charge is good,
no transmitter is
synchronized with the
receiver, no output audio
available
fixed
green
green
on
after the tuning
phase, the
transmitter is
received
the transmitter is correctly
tuned, the bars in the status
menu show the RF levels
received from antenna A and
B
b
atte
ry s
tat
u
s
fixed
green
on/off
on
the batteries charge
of the receiver is
good (>25% lifetime)
the batteries charge of the
receiver is good
slow
blinking
green
on/off
on
the batteries charge
of the receiver is low
(<25% lifetime)
change or put on charge the
batteries as soon as possible
fast
blinking
green
on/off
on
the batteries charge
of the receiver is very
low (<12% lifetime)
change or put on charge the
batteries immediately
red
off
off
battery error
change the batteries
ch
arg
in
g
statu
s
blinking
blue
off
off
during batteries
charging
the batteries are charging
(<90% of complete charge)
blinking
green
off
off
during batteries
charging
the batteries are charging
(≥90% of charge reached)
fixed
green
off
off
during batteries
charging
charge complete
white
green/
red
off
device in bootloader
mode**
*DISPLAY indicate the state of OLED display before the OFF timeout
** to put the MPR30-ENG in boot mode: power on the device push and keep both UP and DOWN buttons
for few seconds (until the led indicators light up, then release the buttons)
Summary of Contents for MPR30-ENG
Page 17: ...16 MECHANICAL DRAWING Note unit is mm...
Page 18: ...17...
