5.
Screw the entire feedthru assembly into the RJ45-ECS housing which is already mounted in the
enclosure. There should be a rubber gasket between the two assemblies. Tighten the feedthru
assembly to create a seal. The final step is to tighten the compression nut until the gaskets are tight
around the Cat5 cable.
Connecting the Cables to the indoor injector:
1.
Connect the antenna cable to the “radio” port
2.
Connect the PC or SWITCH cable to PC/LAN
3.
Connect the 18V AC/DC adapter to POWER connector
After ca 30 seconds, the radio unit will be ready for usage.
