WIRING INSTRUCTIONS
The trailer unit is fitted with a 24 pin plug and separate harnesses for the GPS Integration
option.
WiTi
is installed in parallel with the existing wiring harness on the camper or trailer.
Generally the wiring harness for the camper or trailer will run down the A-frame and chassis and
exit near the axle where it will split to the brakes and lighting circuits. This is a good location
to connect into the harness.
WiTi
works in conjunction with other circuits for lighting and
braking and is installed in parallel with other circuits. Locate the wiring harness on the
camper and connect into the corresponding wiring as per the guide below.
WiTi
wiring is color
coded as per United States standards.
Colour
Label
Function
L-Ind-Lt
Left Indicator
R-Ind-Lt
Right Indicator
Brake-Lt
Brake Light
Head-Lt
Park Lights and Markers
Rev-Lt
Reverse Lights
SrBrake
Electric Brake Output
Earth RTN
Earth Return
IGN-Out
Ignition feed - Not used on WiTi Anti-Theft System
Horn +
Alarm Horn Pos output. Connect to horn
Horn -
Alarm Horn Negative. Connect to horn
LED +
Alarm Status LED 3.3V+. Connect to positive on LED
LED -
Alarm Status LED 3.3V-. Connect to negative on LED
B-Way SW
Optional Break Away switch connection. Connect both wires to the
break away switch on the A-frame of the camper or trailer.
Do not connect to an existing Break Away system
- only connect the
orange wires to a Break Away switch if WiTi is to act as a Break Away as
well as Anti-Theft.
BAT +
12V+ connect to positive terminal on house battery and protect with a
30A fuse.
BAT -
NEG connect to negative terminal on house battery.
Summary of Contents for Anti-Theft System
Page 1: ......
