9
D.
Installing the 50G Dolly (Note: Dollies are not available for the 50G Jr.)
1.
Remove the 1 1⁄4” ball valve.
2.
Remove the two 1⁄4-20 hex head thread cutter screws from the drainpipe support bracket.
3.
Turn drain pipe a quarter turn to the left (counter-clockwise), so that the drain pipe is on an angle.
Make sure the drain pipe clears the framework of the dolly.
4.
CAUTION: HANDLE DRAIN ASSEMBLY CAREFULLY! ONLY SWIVEL THE
DRAINPIPE HORIZONTALLY; NEVER APPLY ANY VERTICAL
PRESSURE OR TORQUE TO THE DRAINPIPE ASSEMBLY.
5.
Lift ball washer onto the dolly (handles in front of machine).
6.
Move drain pipe back into place.
7.
Reinstall support bracket onto washer frame. Slide plate over drain pipe marker hole placements
with a punch or a marker. Drill holes with a 3/16” drill bit.
8.
Reinstall screws.
9.
Reinstall 1 1⁄4” ball valve.
E.
Replacing Rubber Latches
Rubber latches are made of a durable flexible material designed to withstand abuse. They may, however,
eventually require replacement. Refer to the illustration below.
1.
Remove the machine screws from each top and bottom hinge bracket
2.
Replace latch and re-install screws.
F.
Troubleshooting
This section covers most of the typical malfunctions of the WITTEK washer. Use this section in
conjunction with the parts list and diagrams found elsewhere in this manual.
