1
UNPACKING AND INSPECTION
The Wittek Ball Hawk LT Pickers are packed complete with all component parts in one specially designed
corrugated container.
Single Section Ball Hawk LT Picker
One carton contains:
1
−
SINGLE SECTION BALL HAWK LT PICKER COMPLETE
3 – Gang Ball Hawk Ball Picker (Three Section)
One carton contains:
1
−
DRAW BAR
One crate contains:
3
−
PICKER SECTIONS
6
−
PICKER BASKETS
1
−
FRONT WHEEL AND FORK ASSEMBLY COMPLETE WITH HARDWARE
1
−
PUSH BAR (H-BAR) COMPLETE WITH 4 (7") CONNECTING RODS
AND
8 RETAINING PINS
1
−
VEHICLE ATTACHMENT BAR COMPLETE WITH BOLT, WASHER & NUT (ATTACHED TO PUSH BAR)
2
−
POST ASSEMBLY BRACKETS COMPLETE WITH HARDWARE
1
−
ARTICULATING ELBOW
5 – Gang Ball Hawk Ball Picker (Five Section)
Contains the same items listed under the 3-gang in addition to the following:
2
−
ADDITIONAL PICKER SECTIONS
4
−
ADDITIONAL PICKER BASKETS
1
−
LEFT WING COMPLETE WITH 5 1/2” CONNECTING ROD AND RETAINING PIN
1
−
RIGHT WING COMPLETE WITH 5 1/2” CONNECTING ROD AND RETAINING PIN
2
−
ADDITIONAL POST ASSEMBLY BRACKETS COMPLETE WITH HARDWARE
Inspection
Check that all components are accounted for. Contact factory
immediately
if any components are missing.
Inspect all components for visible damage. If any damage is discovered, report it to the shipping carrier and
take the appropriate action. Check that all moving parts
−
front wheel, caster fork, and drum sections move
and turn freely.
CUSTOMER IS RESPONSIBLE FOR FILING ANY DAMAGE CLAIMS WITH THE CARRIER.
