2
ASSEMBLY OF THE SINGLE SECTION BALL HAWK LT PICKER
PLACE THE PICKER BASKETS IN THE APPROPRIATE SPACES.
THE SINGLE SECTION BALL HAWK LT PICKER IS NOW READY FOR OPERATION.
ASSEMBLY OF THE 3-GANG AND 5-GANG
Assemble the picker on level ground.
Installing the front wheel and fork:
1.
Remove shaft collar and pin.
2.
Leave spring and tubing on fork.
3.
Insert front of draw bar downward onto rod of caster fork assembly.
4.
Replace shaft collar and pin.
Installing the rear picker sections:
1.
Remove retaining pin and 5 ½” assembly pin from post assembly bracket (the pin that is mounted
horizontally on post assembly bracket).
2.
Insert mounting sleeve (on frame) in between post assembly bracket.
3.
Insert assembly pin through post assembly bracket and mounting sleeve.
4.
Replace retaining pin.
5.
Remove shaft collar and retaining pin on the vertical rod of the post assembly bracket.
6.
Insert post assembly arm upward through sleeve of draw bar.
7.
Replace shaft collar and retaining pin.
Installing the front picker section:
1.
Remove retaining pin on the vertical rod of the articulating elbow.
2.
Insert articulating elbow upward through sleeve of draw bar.
3.
Replace retaining pin.
4.
Remove shaft collar and pin on the other end of the articulating elbow.
5.
Insert mounting sleeve (on frame) onto T-Bar of articulating elbow.
6.
Replace shaft collar and retaining pin.
Mounting the push bar (H-Bar):
1.
Remove the two connecting rods from the push bar.
2.
Align the mounting sleeves on the end of the push bar with the corresponding mounting sleeves on the
back of the draw bar.
3.
Insert the connecting rods through the sleeves and replace retaining pins.
