cyber
®
simco
®
drive 2 operating manual
en-8
5022-D057946
Revision: 02
2.2 EC directives
The drive amplifier is subject to the following EC directive:
Machinery Directive (2006/42/EC)
Electromagnetic Compatibility (EMC) (2014/30/EU)
RoHS Directive (2011/65/EU)
Startup is prohibited within the scope of the EC directives until it has been determined that the
machine/system in which this drive amplifier is installed corresponds to the regulations within
these directives.
2.3 Commissioning
For installation in machines and systems, start of intended use of the drive amplifier
is prohibited until it has been determined that the machine or system complies with the
provisions of the EC Machinery Directive 2006/42/EC and the EC EMC Directive 2014/30/EU.
For use in residential areas, additional EMC measures are necessary.
It is the responsibility of the manufacturer of the machine or system to ensure that the limit
values, as stipulated by the EMC regulations, are adhered to.
2.4 Hazards
The drive amplifier has been constructed according to current technological standards and
accepted safety regulations.
To avoid danger to the operator or damage to the machine, the drive amplifier may be put
to use only for its intended usage (see chapter 2.6
“Intended use”) and in a technically flawless
and safe state.
2.5 Personnel
Only qualified technicians who have read and understood this manual may carry out work
on the drive amplifier.
Information on the drive amplifier, in particular the safety instructions, must be accessible to all
persons who work with the drive amplifier.
Qualified technicians are characterized by their education and training in the use of electronic
drive technology. They know the relevant standards and accident prevention regulations for
drive technology and can evaluate its use. Potential hazards are recognized immediately.
The local regulations (ICE, VDE, VGB) are known to the technicians and are taken into
account during their work.
In case of ambiguities and functions that are not described or not sufficiently described in the
documentation, the manufacturer or retailer must be contacted.
2.6 Intended use
The drive amplifiers are intended for operation of permanent magnet EC synchronous servo
motors with compatible feedback systems in industrial systems.
Other applications must first be approved by the manufacturer.
They are used in industrial environments. For use in residential areas, additional EMC
measures are necessary. The user must prepare a hazard analysis of the final product.
Summary of Contents for Cyber Simco Drive 2
Page 1: ...5022 D057946 Revision 02 cyber simco drive 2 Operating manual ...
Page 2: ......
Page 56: ......
