Technical data sheets
LP
+
/LPB
+
en-6
2022-D039182
Revision: 03
The different assembly order of LP
+
and LPB
+
is listed in table "Tbl-4".
If you have any questions, get in touch with our Customer Service department.
3.3
Attaching a gearhead to a machine (LPB
+
)
The gearhead exhibits two centering means for the attachment to the machine (A=motor side;
B=gear output side).
A spacer (E) must be assembled between the gearhead and your machine for the dimensionally
accurate positioning of the gearhead if required. This spacer is
not
included in the scope of
delivery and must be provided by the customer.
Fastening screws must be provided by the customer.
You may find the required screw sizes and tightening torques in chapter
mounting onto a machine", table "Tbl-13".
When using hollow profiles (C): Position the toothed belt pulley (D) in the hollow profile prior to
attaching the gearhead.
Coat the fastening screws with a threadlocker (e.g. Loctite 243).
Mount the gearhead with the fastening screws via the through-holes at the machine.
Install the gearhead in such a manner that the type plate remains readable if possible.
Do not use washers (e.g. flat washers, lock washers).
LP
+
LPB
+
—
1.)
1.)
2.)
3.)
—
Tbl-4: Assembly order
