LP
+
/LPB
+
Technical data sheets
Revision: 03
2022-D039182
en-7
3.4
Mounting the motor onto the gearhead
3.4.1
Pre-mounting adapter plate (only LPB
+
)
The following information is valid for only the LPB
+
. On the LP
+
, the adapter plate is already
mounted.
3.4.2
Mounting the motor (LP
+
/ LPB
+
)
No gap is permitted between motor (C) and the adapter plate (D).
The adapter plate (B) along with the four
fastening screws (A) are included in the scope
of delivery of the gearhead.
Place the adapter plate onto the gearhead
housing and hand-tighten the screws at first.
Tighten the screws in diagonal order in at
least two passes to the required tightening
torque. See table "Tbl-5"
Gearhead size LPB
+
Size
Tightening torque [Nm]
070
M4
2,6
090
M6
9,0
120
M6
9,0
Tbl-5: Fastening screws adapter plate
Observe the specifications and safety instructions of the motor
manufacturer.
Observe the safety and processing instructions of the screw-bonding
agents to be used.
Ensure that the motor is mounted if possible in a
vertical direction.
If the motor shaft has a shaft key, remove the
shaft key.
If recommended by the motor manufacturer,
insert a half wedge.
Turn the plug receptacle (A) so that the threaded
pin (B) can be reached through the mounting
bore, see table "Tbl-6"
Push the motor shaft into the plug receptacle of
the gearhead.
The maximum permitted axial forces may not
be exceeded, see Chapter 3.9 "Specifications
for fastening to a motor", table "Tbl-11". The
motor shaft should slip in easily. If this is not
the case, the threaded pin needs to be
loosened more.
The slit of the bushing has to line up with the
groove (if existing) of the motor shaft and be
turned by 90° to the threaded pin, see
table "Tbl-6".
