Assembly
SP
+
en-12
2022-D033540
Revision: 03
z
Tighten the clamping bolt (H) of the clamping hub (D).
z
Screw in plug (A) of the adaptor plate (B).
L
For screw sizes and specified torques refer to table "Tbl-6".
5.3
Mounting the gearhead to a machine
5.4
Mounted components on the gear output side
The output shaft is manufactured as standard in the following versions:
- Smooth output shaft
- Grooved output shaft
- Involute gearing
- Slip-on shaft
z
Please observe for mounting to the slip-on shaft the further instructions in Chapter 5.4.1
"Mounting on the slip-on shaft with shrink disk".
Width across flats [mm]
5
8
10
12
Tightening torque [Nm]
10
35
50
70
Tbl-6: Torques for the plugs
z
Observe the safety and processing instructions of the screw-bonding
agents to be used.
z
Center the gearhead in the machine bed.
z
Smear a screw-bonding agent (for example Loctite 243) onto
the fastening screws.
z
Fasten the gearhead on the machine with the fastening
screws through the through-holes (A).
L
Mount the gearhead in such a way that the type plate
remains legible.
L
Do not use washers (e.g. plain washers, tooth lock
washers).
L
For prescribed screw sizes and torques refer to
Chapter 9.3 "Specifications on mounting onto a machine",
table "Tbl-16".
Distortions during mounting operations can damage the gearhead.
z
Mount gearwheels and toothed belt pulleys onto the output shaft without
forcing.
z
Do not on any account attempt an assembly by force or hammering!
z
Only use suitable tools and equipment for assembly.
z
If you pull on or shrink-fit a gearwheel onto the output shaft, you must
make sure that the maximum permitted static axial forces of the output
bearing (see table "Tbl-7") are not exceeded.
Size SP
+
060
075
100
140
180
210
240
Fa max[N]
9250
10750
18500
31250
49750
83250
97750
Tbl-7: Maximum permitted static axial forces at static bearing statistic (s0) = 1.8 and radial force (Fr) = 0
A
