Operation Manual simco
®
drive
Revision: 11a
4022-D033499
en-7
deut
s
ch
e
n
g
li
s
h
fran
ç
a
is
ita
lia
n
o
españ
ol
日本語
2.2 EC directive
The drive amplifier is subject to the following EC directive:
−
Machinery Directive (2006/42/EC)
−
Electromagnetic compatibility (EMC) (2014/30/EU)
−
RoHS Directive (2011/65/EU)
Startup is prohibited within the scope of the EC directives until it has been determined that the
machine/system in which this drive amplifier is installed corresponds to the regulations within
these directives.
2.3 Startup
For installation in machines and systems, start of intended use of the drive amplifier is
prohibited until it has been determined that the machine or system complies with the
provisions of the EC Machinery Directive 2006/42/EC and the EC EMC Directive 2014/30/EU.
For use in residential areas, additional EMC measures are necessary.
It is the responsibility of the manufacturer of the machine or system to ensure that the
threshold values, as stipulated by the EMC regulations, are adhered to.
2.4 Dangers
The drive amplifier has been constructed according to current technological standards and
accepted safety regulations.
To avoid danger to the operator or damage to the machine, the drive amplifier may be put to
use only for its intended usage (see Chapter 2.6 "Intended use") and in a technically flawless
and safe state.
2.5 Personnel
Only qualified specialist staff who have read and understood these instructions may carry out
work on the drive amplifier.
Information on the drive amplifier, in particular the safety instructions, must be accessible to all
persons who work with the drive amplifier.
Qualified technicians are characterized by their education and training in the use of electronic
drive technology. They know the relevant standards and accident prevention regulations for
drive technology and can evaluate its use. Potential hazards are recognized immediately. The
local regulations (ICE, VDE, VGB) are known to the technicians and are taken into account
during their work.
In case of ambiguities and functions that are not described or not sufficiently described in the
documentation, the manufacturer or retailer must be contacted.
2.6 Intended use
The drive amplifiers are intended for operation of permanent magnet EC synchronous servo
motors with compatible feedback systems in stationary machines and systems.
Other uses must first be approved by the manufacturer.
Installation of the drive amplifiers is only permitted in stationary electrical cabinets or
stationary machine frames. They are used in industrial environments. For use in residential
areas, additional EMC measures are necessary. The user must prepare a hazard analysis
of the final product.
Summary of Contents for SIM2002D-CCSA-CA00-0000-0000
Page 1: ...4022 D033499 Revision 11a simco drive SIM2002D SIM2010D SIM2015D Operating Manual...
Page 2: ......
Page 51: ......
