- If possible, use alkaline batteries instead of zinc-carbon batteries. Alkaline batteries last longer,
particularly outside in low temperatures.
Using addition wireless sensors
The weather station comes with one wireless sensor. However, you can operate the weather station with up
to three wireless sensors. Additional wireless sensors are available via our Amazon online shop.
• The wireless sensors can be located in different rooms or outdoors.
• Every sensor must be assigned its own sensor number (= number of the transmission channel) (1 to 3).
• For the snow and frost warning, the weather station only analyses the information from the sensor with the
lowest number (by default 1). If only one sensor is connected to channel 1, 2 or 3, the display will function
on all 3 channels.
Procedure:
1. Remove the battery compartment cover on the back of the wireless sensor.
2. Set a different sensor number for each wireless sensor with the sliding switches.
3. Put the battery compartment cover back in place on the wireless sensors. If adding another sensor later
or after changing the batteries:
4. Press and hold the
CH
button on the base unit until the radio frequency symbol
flashes. The base
unit will now retrieve the weather information from all available wireless sensors.
Base unit
You can operate the wireless weather station using the power adapter or with batteries. If the wireless
weather station is connected to a power socket, it will be operated using the power mains, even if there are
batteries in the device. Remove depleted batteries from the battery compartment, as they can leak.
A) Power mains operation
ATTENTION
Use only the power adapter included in the delivery for power mains operation.
1. Insert the power adapter included in the delivery into the base unit port.
2. Plug the power adapter into a socket that corresponds to the voltage listed in the Technical Data.
3. Wait several minutes. The base unit needs this time to collect all the weather data.
B) Battery operation
1. Remove the battery compartment cover.
2. Insert 3 LR03 (AAA) / 1.5 V batteries facing in the direction indicated on the bottom of the battery
compartment. Make sure that the poles of the batteries are correct (+/-).
3. Put the battery compartment cover back in place and close it.
4. Wait several minutes. The base unit needs this time to collect all the weather data.
Information
:
The device will lose all information when switching it on again.
