1
Red pilot light
2
Loop for hanging
3
Sliding switch 1 2 3: Set sensor number (transmission channel)
4
Battery compartment
If you wish to use only the wireless sensor included in the delivery, as a general rule, the
transmission channel does not need to be changed.
This is only necessary if you wish to use additional wireless sensors; see
“Using additional
wireless
sensors”.
Initial setup
Follow the instructions in the order described and first put the batteries in the wireless
sensor. This is the only way for the device to function without any problems.
Do not press
any buttons while switching the device on.
Wireless sensor
1. Remove the battery compartment cover on the back of the wireless sensor.
2. Insert 2 LR6 (AA) / 1.5 V batteries facing in the direction indicated on the bottom of the
battery compartment. Make sure that the poles of the batteries are correct (+/-). As soon as
the wireless sensor is receiving power, the red pilot light will light up and thus display that
data is being transmitted to the base unit.
3. Put the battery compartment cover back in place.
- Do not use batteries that have a voltage that is too low (only 1.2 V instead of 1.5 V). This
affects the accuracy of the measurements, among other things.
