Bedienungsanleitung Nr. 9999-041-0
Seite 4
B7202_E_1
.pmd
12.06.2003
Initiate programming
Select P - No. 1
Confirm the entry
Select the user combination to be deleted, e.g. 2 °
Confirm the entry
Enter the 6-digit master combination
Confirm the entry
Re-confirm the entry
Cancel
The previous user
combination will be
retained if there is an error in the
deletion sequence.
°
= UNo. 1
= UNo. 5
If fewer than 3 user combinations
are programmed, then any
combination interlock which may
have been programmed
previously will have to be
deleted. See Section 8.5.2
8.2.1 Deleting a user combination
A user combination can be deleted only by master combination owner and only with the electronic lock open.
Green LED blinks once
OK = green LED blinks once
and low-high tone sounds.
Error = 12 high-pitched
tones and red LED lights.
Function
Operation, button(s)
Response
Comments
Explanation:
Timed delay period
=
Period between entering a combination the first time and the time
at which the electronics clear the lock for entry
of a combination the second time, to actually open the safe.
Relaese period
=
Period of time available, once the timed delay period has
expired, to open the safe by entering a combination.
Timed delay period of 1 to 3 minutes
=
30 second release period
Timed delay period of 4 to 10 minutes
=
1 minute release period
Timed delay period of 11 to 59 minutes
=
2 minute release period
8.3 Programming a timed delay period
Possible only with the electronic lock open and only with the master combination.
Initiate programming
Select P - No. 3
Confirm the entry
Enter 6-digit master combination, e.g.
Confirm the entry
Enter timed delay period °. e.g. 1 minute
Confirm the entry
Cancel
°
= 1 minute to
= 59 minutes
Green LED blinks once
OK = green LED blinks once
and low-high tone sounds.
Error = 12 high-pitched
tones and red LED lights.
Function
Operation, button(s)
Response
Comments
8.3.1 Opening the lock with the timed delay function activated
A timed delay period, once it has been programmed, is applicable
to all combinations. Once a valid combination has been entered
the green LED will blink at 5-second intervals during the timed
delay period. During this delay period the electronics will not
respond to any keypad entries. The end of this timed delay period
is signaled by 15 signal tones; the green LED lights. The release
period begins running and you can now open the electronic lock
by
entering your combination again
.
If a combination interlock was programmed (see
Sections 8.5 and 8.5.1), then only one combination need
be entered during the release period.
If an invalid combination is entered or the „C“ button is
pressed during the release period, then the entire opening
procedure will have to be repeated. This means that, once a
valid combination has been entered, the timed delay period will
begin running anew.
