2
Installation instructions Primor 1000
09.11.2012
1 General instructions
•
Please read the operating instructions carefully, before activating the lock.
1.1 Liability notes
• The mounting of the electronic lock with input unit has to be carried out according to the installation instruction.
• We point out that this installation instruction is part of the VdS-certification and non-compliance leads to the loss of this
certification.
• By opening the lock cover warranty of the manufacturer will be void.
• The electronic lock has to be protected against external attacks.
• Do not insert any lubricants or other substances into the electronic lock.
2.1 Installing the lock
• When the swing bolt lock is used with another lock, the boltwork has to be set up, so that the swing bolt lock inevitably locks
first.
• The swing bolt lock has to be fixed with 3 x M6 screws in the prepared drillings in order to ensure a permanent hold.
• An independent loosening of the screws has to be avoided. It is recommended to put lock washers underneath the screw’s
head. To avoid malfunctions, turn the screws with a maximum turning force of 3.5 – 5 Nm.
• After the installation the lock’s bolt may not be loaded.
• The swing bolt lock is maintenance free in normal domestic and office surroundings. After approx. 10,000 closures it is
recommended to carry out a security and functional test of the swing bolt lock.
2 Lock installation
The swing bolt lock has got standard fixing points and can be mounted in all 4 directions (right-hand, left-hand, up, down). In
order to fix the swing bolt lock, 3 threaded holes M6 have to be drilled according to the figure below.
Fig. 1: Installation dimensions swing bolt lock
Fig. 2: Mounting situation